OPEN ACCESS

Articles online

Construction and Characterization of an Indoor Smog Chamber for Measuring the Optical and Physicochemical Properties of Aging Biomass Burning Aerosols

Category: Aerosol and Atmospheric Chemistry

Accepted Manuscripts
DOI: 10.4209/aaqr.2018.06.0243
PDF

Export Citation:  RIS | BibTeX

Damon M. Smith1, Marc N. Fiddler2, Kenneth G. Sexton3, Solomon Bililign 2,4

  • 1 Applied Sciences and Technology Program, North Carolina A&T State University, Greensboro, NC 27411, USA
  • 2 NOAA-ISET Center, North Carolina A&T State University, Greensboro, NC 27411, USA
  • 3 Department of Environmental Sciences and Engineering, Gillings School of Global Public Health, University of North Carolina at Chapel Hill, Chapel Hill, NC 27514, USA
  • 4 Department of Physics, North Carolina A&T State University, Greensboro, NC 27411, USA

Highlights

A new Combustion-Chamber System with 9 m3 FEP batch reactor is built at NCAT.
Combustion is done in a tube furnace that allows controlled burning conditions.
Particle wall loss rates are determined using biomass burning (BB) aerosols.
Facility effectively for measuring optical properties of fresh and aged BB aerosols.
Filter samples from the chamber used for chemical and morphological studies.


Abstract

We describe here the construction and characterization of a new combustion-chamber system (NCAT Chamber) for studying the optical and physicochemical properties of biomass burning (BB) aerosols. This system is comprised of a ~9 m3 fluorinated ethylene propylene (FEP) film reactor placed in a temperature-controlled room that uses a tube furnace for combusting biomass under controlled conditions. Optical properties are measured using a cavity ring-down spectrometer, nephelometer, condensation particle counter, and differential mobility analyzer, in conjunction with other analytical instruments, such as NOx, O3, CO, and CO2 analyzers, a gas chromatograph, and filter particle samplers for determining the physicochemical and morphological properties. Construction details and characterization experiments are described, including measurements of BB particulate size distribution and deposition rate, gas wall loss rates, dilution rate, light intensity, mixing speed, temperature and humidity variations, and air purification method. The wall loss rates for NO, NO2, and O3 were found to be (7.40 ± 0.01) × 10−4, (3.47 ± 0.01) × 10−4, and (5.90 ± 0.08) × 10−4 min−1 respectively. The NO2 photolysis rate constant was 0.165 ± 0.005 min–1, which corresponds to a flux of (7.72 ± 0.25) × 1017 photons nm cm−2 s−1 from 296.0−516.8 nm. Particle deposition rate was found to be (9.46 ± 0.18) × 10−3 min−1 for 100 nm pine BB particles. Preliminary results of the single scattering albedo of fresh and aged BB aerosols are also reported.

Keywords

Biomass burning aerosols Optical properties of aerosols Smog chamber Single scattering albedo Fresh and aged aerosols


Related Article

Identification of Long-range Transported Polycyclic Aromatic Hydrocarbons in Snow at Mt. Tateyama, Japan

Kazuichi Hayakawa , Ning Tang, Edward G. Nagato, Akira Toriba, Kazuma Aoki
Accepted Manuscripts
DOI: 10.4209/aaqr.2018.05.0153
PDF
;