OPEN ACCESS

Articles online

Effects of Three-partitioned Horizontal Inlet and Clean Air on Collection Efficiency and Wall Loss of Slit Virtual Impactors

Category: Aerosol Physics and Instrumentation

Volume: 18 | Issue: 5 | Pages: 1131-1140
DOI: 10.4209/aaqr.2017.12.0563
PDF | RIS | BibTeX

Muhammad Zeeshan Zahir, Ji-Eun Heo, Se-Jin Yook

  • School of Mechanical Engineering, Hanyang University, Seoul 04763, Korea

Highlights

Three-partitioned horizontal inlet was used to enhance virtual impactor performance.
Collection efficiency and wall loss were examined both numerically and experimentally.
Effect of three-partitioned horizontal inlet was compared to that of vertical inlet.
With three-partitioned horizontal inlet, cut-off size and wall loss were much reduced.
Moreover fine particle contamination in minor flow section was reduced to nearly zero.


Abstract

A numerical and experimental investigation comparing two configurations for a slit nozzle virtual impactor, one using a three-partitioned horizontal inlet and the other using a typical vertical inlet, was conducted to improve collection efficiency and reduce wall loss. All parameters, such as the length and width of the acceleration nozzle, the width of the collection nozzle, the distance between the two nozzles, and the inlet flow rate, were kept constant, and only the inlet configuration was changed. The ratio of the minor to the total flow rate was fixed at 0.1. Parametric analysis was performed to study the flow-rate influence of incoming clean air and aerosol on the performance of the three-partitioned horizontal inlet virtual impactor. The square root of the Stokes number, (Stk)1/2, was used to characterize the collection efficiency and wall loss of both configurations. It was observed that by using the three-partitioned horizontal inlet, the cut-off diameter was reduced from (Stk)1/2 = 0.80 to (Stk)1/2 = 0.41, and the wall loss near the cut-off diameter decreased from 25%–45% to below 4.5%. Moreover, using the three-partitioned horizontal inlet reduced the contamination by particles smaller than the cut-off size in the minor outflow section of the virtual impactor to almost 0%.

Keywords

Virtual impactor Slit nozzle Collection efficiency Wall loss Stokes number


Related Article

Thermophoresis and Brownian Motion Effects on Nanoparticle Deposition Inside a 90° Square Bend Tube

Zhao-Qin Yin, Xian-Feng Li, Fu-Bing Bao , Cheng-Xu Tu, Xiao-Yan Gao
Accepted Manuscripts
DOI: 10.4209/aaqr.2018.02.0047
PDF
;