OPEN ACCESS

Articles online

Carbonaceous Nanoparticle Layers Prepared using Candle Soot by Direct- and Spray-based Depositions

Category: Aerosol Physics and Instrumentation

Volume: 18 | Issue: 4 | Pages: 856-865
DOI: 10.4209/aaqr.2017.10.0426
PDF

Export Citation:  RIS | BibTeX

Ferry Faizal1, M.P. Khairunnisa1,2, Shunichiro Yokote2, I. Wuled Lenggoro 1,3

  • 1 Graduate School of Bio-Applications and Systems Engineering, Tokyo University of Agriculture and Technology, Koganei, Tokyo 184-8588, Japan
  • 2 Malaysia - Japan International Institute of Technology, Universiti Teknologi Malaysia, 54100 Kuala Lumpur, Malaysia
  • 3 Department of Chemical Engineering, Tokyo University of Agriculture and Technology, Koganei, Tokyo 184-8588, Japan

Highlights

"Dry" and spray routes to deposition of soot particles from the candle are proposed.
Super-hydrophobic particle layers can be derived from freshly-formed soot.
Particle layers derived from the flame tip show hydrophilic characters.
Electrospraying is invariant to the bond structure of soot particles.
Deposition by spray route can obtain more controllable soot particle layers.


Abstract

To investigate the properties and structures of soot particles derived from candle combustion, two deposition routes were performed. In "Route-1,” the aerosol (soot) particles were collected by direct exposure of a substrate in a chamber with controlled airflows. In "Route-2,” deposited soot nanoparticles was transferred into suspension and subsequently, the deposition of particles on to the substrate was achieved by an electrospray. Raman spectral analysis has shown the difference of G-band intensity relative to D-band between hydrophobic and hydrophilic particle layers obtained from different collection regions of the candle flame. It also reveals the effect of airflows during the collection to the ratio of the D to G peak. Meanwhile, the Raman spectra of the particles seem invariant to the preparation methods of suspension and electrospray deposition process. From the curve gradient of spectroscopy (190–2500 nm) results, the electrospray-deposited particle layers (Route-2) show higher absorbance in the near-infrared region compared to direct-deposited particle layers (Route-1). This change in the spectrum may due to the change in morphology of nanoparticle layers formed by each route.

Keywords

Aerosol deposition Carbonaceous aerosols Nanostructured materials Optical spectroscopy Soot


Related Article

;