OPEN ACCESS

Articles online

Cleaning of Filter Cartridges with Convergent Trapezoidal Pleat Shape via Reverse Multi-Pulsing Jet Flow

Category: Others

Article In Press
DOI: 10.4209/aaqr.2016.12.0539
PDF | RIS | BibTeX

Shaowen Chen 1, Da-Ren Chen2

  • 1 School of Energy Science and Engineering, Harbin Institute of Technology, Harbin, Heilongjiang 150001, China
  • 2 Particle Lab, Department of Mechanical and Nuclear Engineering, Virginia Commonwealth University, 401 West Main Street, Richmond, VA 23294, USA

Highlights

Reverse multi-pulsing jet cleaning of cartridges was studied.
Filter cartridges with novel convergent trapezoidal pleats was modeled.
Four multi-pulsing jet cleaning modes were investigated.
Improved cleaning efficiency and quality via multi-pulsing jet for cartridges was evidenced.


Abstract

Pleat structure and tight pleat spacing of pleated filter cartridges often lead to patchy cleaning when applying reverse pulsing technique process to regenerate filter media, consequently resulted in the decrease of the efficiency and quality of reverse pulsed-jet cleaning as well as the service lifetime of filtration units. For improving the non-uniform cleaning or patchy cleaning, a novel convergent trapezoidal pleat shape was used in multi-pulsing reverse flow cleaning. A transient 3D CFD simulation in a simple filtration system with a single filter cartridge was carried out under the four multi-pulsing modes. The effects of multi-pulsing flow cleaning on the cleaning efficiency and quality were systematically investigated. Compared with single-pulsing cleaning mode, the peak pressure differences at the upper regions all became positive because of the increased cleaning frequency, and thus which would be crucially important for improving the local cleaning mechanical stresses and cleaning efficiency. Moreover, the extra peak-pressure augment in the lower regions of filter cartridge also had a positive influence of local cleaning efficiency. For the multi-pulsing scheme of Waveform #4, the peak pressure difference at the section 4 increased by 11.2% than the single-pulsing scheme. The related action mechanism had high correlation with the interaction of residue gas and following jet. Finally, the improvement of the cleaning efficiency and quality are expected to be validated under the decreasing tank pressure and real permeability.

Keywords

Pleated filter cartridge Reverse multi-pulsing cleaning Cleaning efficiency Cleaning quality Convergent trapezoidal pleat shape


Related Article

Preparation of Fe2O3/Al2O3 and Fe2O3/TiO2 Pellets as Oxygen Carrier for Chemical Looping Process

Young Ku , Pao-Hsien Lin, Hsuan-Chih Wu, Yu-Cheng Liu, Yao-Hsuan Tseng, Hao-Yeh Lee
Accepted Manuscripts
DOI: 10.4209/aaqr.2017.03.0121
PDF

ENSO Influence on Coastal Fog-Water Yield in the Atacama Desert, Chile

Camilo del Río , Juan-Luis Garcia, Pablo Osses, Nicolás Zanetta, Fabrice Lambert, Daniela Rivera, Alexander Siegmund, Nils Wolf, Pilar Cereceda, Horacio Larraín, Felipe Lobos
Accepted Manuscripts
DOI: 10.4209/aaqr.2017.01.0022
PDF
;