OPEN ACCESS

Articles online

Organic Nanoaerosol in Coal Mines: Formation Mechanism and Explosibility

Category: Aerosol and Atmospheric Chemistry

Volume: 17 | Issue: 7 | Pages: 1735-1745
DOI: 10.4209/aaqr.2016.12.0533
PDF | RIS | BibTeX

Andrei Onischuk 1,2,3, Sergey Dubtsov1, Anatoly Baklanov1, Sergey Valiulin1,3, Pavel Koshlyakov1, Dmitry Paleev4, Vladimir Mitrochenko1, Valery Zamashchikov1,2, Aleksey Korzhavin1

  • 1 Institute of Chemical Kinetics and Combustion, Novosibirsk 630090, Russia
  • 2 Novosibirsk State University, Novosibirsk 630090, Russia
  • 3 Novosibirsk State Pedagogical University, Novosibirsk 630126, Russia
  • 4 Institute of Coal, Kemerovo 650610, Russia

Highlights

The mechanism of aerosol formation in the coal mine longwall area is studied.
Two types of particles are present in the coal mine atmosphere: nanosized and micron-sized.
Nanosized particles are formed in organic vapor homogeneous nucleation.
Micron-sized particles are from direct crushing of coal.
Organic particles may have a significant effect on the explosibility in coal mines.


Abstract

The mechanism of aerosol formation in coal mines during the operation of a longwall shearer was studied using a diffusion battery, optical counter, and by means of Transmission Electron Microscopy (TEM). The aerosol number concentration was measured to be (2–5) × 105 cm–3. The aerosol size spectrum contained three modes, at about 10, 100, and 1000 nm. The first mode relates to single (primary) particles formed by the homogeneous nucleation of supersaturated organic vapor. This vapor is formed by the evaporation of organic matter from coal due to the release of frictional heat at the interface between the cutting pick and coal. The second mode relates to the particles that are aggregates formed by coagulation of primary particles. The third mode relates to the particles formed by direct grinding of coal by the cutting picks.

The laboratory studies of organic aerosol formation in a flow coal grinding machine showed that the size spectrum and morphology of aerosol from the grinding machine were close to those in the coal mine. This fact confirms the thesis that the release of frictional heat is the driving force for the formation of organic aerosol. The analysis of gas-phase products in the outflow of the grinding machine showed that along with aerosol formation, gas products such as CO, CO2, CH4, C2H6, H2O are released from coal due to the frictional heat. Methane and ethane concentrations in the flow reached 10 and 5 vol. %, respectively.

To demonstrate the explosibility of organic aerosol, the combustion of organic aerosol in the air was studied. It was shown that the lower explosive limit for organic aerosol is less than 50 g m–3. A conclusion is made that the formation of organic aerosol is to be taken into account when estimating the safety limits in coal mines.

Keywords

Aerosol generation Agglomeration Carbonaceous aerosols Nucleation Homogeneous Air pollution


Related Article

Spectral Properties of Black Carbon Produced during Biomass Burning

Chaithanya D. Jain , Harish S. Gadhavi, Tushar Wankhede, Kanakaraju Kallelapu, Suryasree Sudhesh, Lidiya N. Das, Rahul U. Pai, Achutan Jayaraman
Accepted Manuscripts
DOI: 10.4209/aaqr.2017.03.0102
PDF
;