About AAQR

Aims and Scope

Articles online
For contributors
Call for Papers
Guideline for the
Special Issue Proposal
Subscription
Information

Advertising

Contact Us
 
Search for  in   Search  Advanced search  

 

Volume 10, No. 4, August 2010, Pages 367-377 PDF(3.1 MB)  
doi: 10.4209/aaqr.2010.01.0002   

Source Characterization and Apportionment of PM10 in Panzhihua, China

Yong-hua Xue1, Jian-hui Wu1, Yin-chang Feng1, Li Dai1, Xiao-hui Bi1, Xiang Li1,2, Tan Zhu1, Shi-bao Tang3, Mei-fang Chen3

1 State Environmental Protection Key Laboratory of Urban Ambient Air Particulate Matter Pollution Prevention and Control, College of Environmental Science and Engineering, Nankai University, Tianjin, 300071, China
2 Department of Computer Science, University of Georgia, Athens, GA, USA
3 Panzhihua Academy of Environmental Sciences

 

Abstract

 

A total of 258 particulate matter (PM10) filter samples and 69 source samples applicable to receptor model source apportionment were collected and chemically analyzed from February to August 2007 in Panzhihua, China. Contributive sources were identified and the chemical profiles were reported for resuspended dust, paved and unpaved road dust, coal-fired power plant exhaust, emissions from coking plants and other industrial sources in Panzhihua. All samples were analyzed for 19 elements (Na-Pb), two ions (NO3 and SO42–) and organic and total carbon. Elevated abundances of geological components (Al, Si, Ca and Fe) from fugitive dust materials and elements (Ti, Cr, Mn, Cu and Zn) from special industry plants were found in the profiles. The contributions to the ambient PM10 levels at six sites in three seasons (spring, summer and winter) were estimated using a chemical mass balance receptor model. The concentration of PM10 was high (150 μg/m3) on winter days and low in summer and spring (133 and 129 μg/m3, respectively). Apportionment results indicate that coal combustion ash, iron and steel industry dust, vehicle exhaust and secondary SO42– were major contributors, accounting for about 70% of PM10. More attention should be paid to particulate matter emitted by iron and steel manufacturing facilities in view of high contribution and potentially toxic metals.

 

 

Keywords: Chemical mass balance; Particulate matter; Source apportionment.

 

 

Copyright © 2009-2014 AAQR All right reserved.