About AAQR

Aims and Scope

Articles online
For contributors
Call for Papers
Guideline for the
Special Issue Proposal
Subscription
Information

Advertising

Contact Us
 
Search for  in   Search  Advanced search  

 

Volume 15, No. 4, August 2015, Pages 1662-1671 PDF(11.11 MB)  
doi: 10.4209/aaqr.2014.11.0286   

Influence of Sr Substitution on Catalytic Performance of LaMnO3/Ni Metal foam Composite for CO Oxidation

Po-Yang Peng1, Yi-Chiun Tsai2, Jen-Taut Yeh2, Yung-Sen Lin3, Chao-Ming Huang2

1 Department of Chemical Engineering and Biotechology, National Taipei University of Technology, Taipei, Taiwan
2 Department of Materials Engineering, Kun Shan University, Tainan, Taiwan
3 Department of Chemical Engineering, Feng Chia University, Taichung, Taiwan

 

Highlights
  • La1-xSrxMnO3/MF composite catalysts were prepared without the use of a binder.
  • Molar ratio of Sr/La markedly influenced catalytic oxidation of CO of catalyst.
  • La0.8Sr0.2MnO3/MF exhibited the highest activity and stability among the samples.
  • High performance was ascribed to mesoporous structure and adsorbed oxygen species.

Abstract

 

A series of Sr-substituted lanthanum manganite perovskites, La1-xSrxMnO3 (LSMO, x = 0, 0.1, 0.2, and 0.3), with mesoporous structures were prepared and coated onto a three-dimensional Ni metal foam (MF) as composite catalysts. The catalytic performances of La0.8Sr0.2MnO3/MF and La0.7Sr0.3MnO3/MF were found to be superior to those of La0.9Sr0.1MnO3/MF, LaMnO3/MF, and LaMnO3 powder in terms of catalytic oxidation of carbon monoxide with air. Under the reaction conditions (1.5 vol.% CO and air balance at a weight hourly space velocity of 90,000 hr–1), La0.8Sr0.2MnO3/MF reached 100% catalytic oxidation of CO, which is 27% higher than that of LaMnO3 powder. Sr substitution induced an increase of Mn4+ and adsorbed surface oxygen species (O, O2, or O22–), which increased the number of active centers for oxidation and thus enhanced the oxidizing ability of the catalyst. The high activity and excellent stability of La0.8Sr0.2MnO3/MF catalyst can be ascribed to a synergistic effect between the mesoporous structure and the high number of adsorbed oxygen species of the catalyst as well as the interconnected three-dimensional reticular configuration of the nickel metal support, which increases the number of active sites and enhances mass transfer for CO and O2. La0.8Sr0.2MnO3/MF composite can potentially be used in catalytic converters for CO removal of automotive exhaust gases.

 

 

Keywords: LSMO; Nickel metal foam; Catalytic oxidation; Carbon monoxide.

 

 

Copyright © 2009-2014 AAQR All right reserved.