About AAQR

Aims and Scope

Articles online
For contributors
Call for Papers
Guideline for the
Special Issue Proposal
Subscription
Information

Advertising

Contact Us
 
Search for  in   Search  Advanced search  

 

Volume 14, No. 3, April 2014, Pages 1003-1016 PDF(520 KB)  
doi: 10.4209/aaqr.2013.04.0129   

An Experimental Study on Performance Improvement of the Stairmand Cyclone Design

Chia-Wei Hsu1, Sheng-Hsiu Huang1, Chih-Wei Lin1, Ta-Chih Hsiao2, Wen-Yinn Lin3, Chih-Chieh Chen1

1 National Taiwan University, Taipei, Taiwan
2 National Central University, Jhongli City, Taoyuan County, Taiwan
3 National Taipei University of Technology, Taipei, Taiwan

 

Abstract

 

The cyclone is widely used as air cleaning device. Many studies have been made on how to enhance its particle collection efficiency or reduce the airflow resistance, but usually the alteration of only one dimension is discussed, and only the collection efficiency or the airflow resistance is considered. Some studies have compared the 50% cut-off size under the same airflow resistance, or compared the airflow resistance under the same 50% cut-off size to obtain the optimal configuration. Yet steps like this take long time to complete, which makes it difficult to compare the cyclone efficiency comprehensively.
    This work adopts the cyclone quality factor as the performance index, and the cyclone designed by Stairmand is adopted as the basic configuration in the present study. With the cyclone body diameter (D) fixed, we vary the cyclone length (H), inlet height (a) and width (b), cyclone length without the cone (hb), cone height (hc), cone bottom diameter (B), and vortex finder length (S). The results show that each of these design parameters has a different impact on the cyclone performance.
    Based on the cyclone quality factor, equivalent to the filter quality factor, it is found that the H and S of the Stairmand cyclone are already the optimal conformations. The cyclone performance could be further improved, if further changes could be made to the other conformations, for example, narrowing down the inlet (adjusting a/b from 13/5 to 20/3.2), reducing the cone bottom diameter (adjusting B from 9 mm to 4 mm) and decreasing the vortex finder diameter (adjusting De from 13 mm to 8 mm), The cyclone quality factor appears to be a function of the volumetric flow rate. Results demonstrate that while the air flow is fixed at 15 L/min, the newly improved cyclone could perform 12 times better than the Stairmand cyclone, according to the cyclone quality factor.

 

 

Keywords: Cyclone quality factor; Cyclone design; Cyclone performance.

 

 

Copyright © 2009-2014 AAQR All right reserved.