About AAQR

Aims and Scope

Articles online
For contributors
Call for Papers
Guideline for the
Special Issue Proposal
Subscription
Information

Advertising

Contact Us
 
Search for  in   Search  Advanced search  

 

Volume 17, No. 1, January 2017, Pages 290-301 PDF(1.57 MB)  
doi: 10.4209/aaqr.2016.02.0058   

A Numerical Study of the Particle Penetration Coefficient of Multibended Building Crack

Yi Yang

School of Energy Science and Engineering, Central South University, Changsha 410083, China

 

Highlights
  • The fraction of vertical wall area has little effect on fine particle penetration.
  • Increasing fraction of vertical wall area will increase large particle penetration.
  • More particles can travel through L-shaped crack with increasing crack height.
  • Particle penetration is same for equal length multibended crack.

Abstract

 

In this paper, the particle penetration coefficient of a multibended building crack was numerically investigated in detail. A steady laminar flow field was obtained by solving continuity and Navier–Stokes equations. The Eulerian method considering gravitational sedimentation and Brownian diffusion was employed to describe particle behavior and was validated using the experimental data. This study evaluated the particle penetration coefficient of straight-through, L-shaped, double-bend, and four-bend cracks by considering the following impact factors: the ratio of the vertical–horizontal wall area, crack height, and inclined wall angle. The results show that the ratio of the vertical–horizontal wall area is a key parameter for evaluating the particle deposition rate. When particles travel through the L-shaped crack, the penetration coefficient of fine particles is the same for cracks with different ratio of the vertical-horizontal wall area, and the penetration coefficient of large particles increases with increasing the ratio of the vertical-horizontal wall area. The particle diameter band with a penetration coefficient higher than 80% extends with increasing crack height. If L-shaped cracks have constant ratio of the vertical-horizontal wall area, then the particle has equal penetration coefficients when traveling through L-shaped cracks inclined at different angles. Particles traveling through multibended cracks with equal length, height, and ratio of the vertical-horizontal wall area exhibit the same trend for penetration coefficients.

 

 

Keywords: L-shaped crack; Double-bends crack; Four-bends crack; Diffusion deposition; Gravitational settling deposition.

 

 

Copyright © 2009-2014 AAQR All right reserved.