About AAQR

Aims and Scope

Articles online
For contributors
Call for Papers
Guideline for the
Special Issue Proposal
Subscription
Information

Advertising

Contact Us
 
Search for  in   Search  Advanced search  

 

Volume 17, No. 4, April 2017, Pages 1063-1072 PDF(1.8 MB)  
doi: 10.4209/aaqr.2016.06.0258   

Study of the Oil Mist Filtration Performance: Pressure Drop Characteristics and Filter Efficiency Model

Jie Zhang, Wuxuan Pan, Zhengwei Long, Congcong Wang, Zhuangbo Feng

Tianjin Key Laboratory of Indoor Air Environmental Quality Control, School of Environmental Science and Engineering, Tianjin University, Tianjin, China

 

Highlights
  • The filter performance for oily particles was investigated experimentally.
  • A filter efficiency model based on the pure liquid model was developed.
  • Changes of oil content varied both the particle diameter and filter saturation.

Abstract

 

Oil mists, which are colloids composed of solid core particles surrounded by oil, are commonly removed from air by fibrous filters. However, unlike the filtration of pure solid or pure liquid particles, mist filtration is not yet fully understood. This study performed a series of experiments to investigate filter performance throughout a clogging process and evaluated the influence of oil content on the variance of pressure drop and filter efficiency. A model was developed for predicting the efficiency of the colloid particles and used to explain how the variance of the oil content changed the efficiency. Results showed that the filter became saturated, showing a constant pressure drop and efficiency, after a relatively short period of fluctuation. The particles with higher oil content used less time to reach the equilibrium state, and had a lower pressure drop and higher efficiency. The amounts of oil coated on the solid cores influenced both the particle diameters and the saturation of filters. Filter efficiency can notably increase with decreasing saturation until saturation was less than 0.5, and the efficiency of particles that were most affected were those with diameters of approximately 30 nm and 500 nm.

 

 

Keywords: Oil mist; Filtration; Pressure drop; Filter efficiency; Saturation.

 

 

Copyright © 2009-2014 AAQR All right reserved.