About AAQR

Aims and Scope

Articles online
For contributors
Call for Papers
Guideline for the
Special Issue Proposal
Subscription
Information

Advertising

Contact Us
 
Search for  in   Search  Advanced search  

 

Volume 15, No. 2, April 2015, Pages 600-610 PDF(1.68 MB)  
doi: 10.4209/aaqr.2014.01.0009   

Enhancement of Air Filter with TiO2 Photocatalysis for Mycobacterium Tuberculosis Removal

Chuleewan Thunyasirinon1, Pipat Sribenjalux2, Sitthisuntorn Supothina3, Paradee Chuaybamroong4

1 Public Health Program, Graduate School, KhonKaen University, Thailand
2 Department of Clinical Microbiology, Faculty of Associated Medical Sciences, Khon Kaen University, Thailand
3 National Metal and Materials Technology Center (MTEC), National Science and Technology Development Agency, Thailand.
4 Department of Environmental Science, Faculty of Science and Technology, Thammasat University, Thailand

 

Highlights
  • Low grade and high grade air filters enhanced with photocatalysis could be used for TB control.
  • Dark and light conditions have the effect on properties of TiO2 coated filter.
  • Longer UVA initiation period could enhance the bacterial removal efficiency.

Abstract

 

HEPA filter is normally recommended for removal of Mycobacterium tuberculosis from the airstream. Due to its high cost, a cheaper air-filter substitution is proposed in this study. Both low- and high-grade glass fiber air filters were coated with 5% TiO2 using either polyethylene glycol (PEG), Silane (Si-69), or DURAMAX (D-3005) as a binder. The coated filter was placed in a test duct and irradiated with UVA at an intensity of 4.85 ± 0.41 mW/cm2 to investigate photocatalysis for M. tuberculosis. The effects of dark and light conditions as well as initial exposure to UVA on bacterial removal were studied. Silver-doped and iron-doped TiO2 at different concentrations were also tested using face velocities of 0.1 and 1 m/s and humidity levels of 50 ± 10% and 70 ± 10% RH.
    The most appropriate binder for coating TiO2 onto filters was 3% D3005. Using 0.1% metal-doping, 100% removal efficiencies were found. Dark/light conditions affected the hydrophobic/hydrophilic properties of TiO2-coated filters and the removal efficiencies. The removal rate could be increased by extending the warm up period of the lamps. When the face velocity was increased, the removal efficiency dropped in both filters. Similarly, high humidity adversely affected the removal efficiency, particularly with the coated high grade air filter.

 

 

Keywords: Tuberculosis; Binder; Microorganism disinfection; TiO2 immobilized filter; Air filter.

 

 

Copyright © 2009-2014 AAQR All right reserved.