About AAQR

Aims and Scope

Articles online
For contributors
Call for Papers
Guideline for the
Special Issue Proposal
Subscription
Information

Advertising

Contact Us
 
Search for  in   Search  Advanced search  

 

Volume 11, No. 6, November 2011, Pages 632-642 PDF(368 KB)  
doi: 10.4209/aaqr.2010.09.0080   

Indoor and Outdoor Particle Number and Mass Concentrations in Athens. Sources, Sinks and Variability of Aerosol Parameters

Evangelia Diapouli1, Konstantinos Eleftheriadis1, Angeliki A. Karanasiou1, Sterios Vratolis1, Ove Hermansen2, Ian Colbeck3, Mihalis Lazaridis4

1 E.R.L., Institute of Nuclear Technology and Radiation Protection, N.C.S.R. Demokritos, 15310 Ag. Paraskevi, Attiki, Greece
2 NILU, PO Box 100, N-2027 Kjeller, Norway
3 University of Essex, Dept of Biological Sciences, Wivenhoe Park, Colchester CO4 3SQ, Essex, UK
4 Technical University of Crete, Department of Environmental Engineering, Chania, Crete, Greece

 

Abstract

 

The scope of this work was to characterize PM mass and number concentration at typical residential microenvironments in the centre of Athens and to examine the relative contribution of the indoor and outdoor sources. Three residential flats located in densely populated residential areas were studied, during a warm and cold period of 2002. PM10, PM2 and black carbon (BC) mass concentrations, as well as ultrafine and accumulation mode particle number size distributions were recorded indoors and outdoors simultaneously. Outdoor concentrations of all size fractions were significant, and indicative of urban sites affected by heavy traffic. Indoor levels were generally lower than the corresponding outdoor ones. Nevertheless, elevated indoor concentrations were recorded, caused by increased ambient air penetration in the indoor microenvironments and/or indoor particle generation. The mean 24-hr indoor PM10 concentration at all residences was 35.0 ± 10.7 μg/m3 during the warm period and 31.8 ± 7.8 μg/m3 during the cold period. The corresponding PM2 concentration was 30.1 ± 11.1 μg/m3 and 27.2 ± 3.6 μg/m3 during warm and cold periods, respectively. Regression analysis of indoor and outdoor concentration data revealed that indoor BC may be considered mainly of outdoor origin. A large fraction of the outdoor-generated PM2 and ultrafine and accumulation mode particles also seems to penetrate indoors, causing elevated indoor levels. Regarding indoor particle generation, cooking was the strongest contributor in residential microenvironments.

 

 

Keywords: PM10/PM2; Particle number size distribution; Black carbon; Residential microenvironment; Indoor/outdoor sources.

 

 

Copyright © 2009-2014 AAQR All right reserved.