About AAQR

Aims and Scope

Articles online
For contributors
Call for Papers
Guideline for the
Special Issue Proposal
Subscription
Information

Advertising

Contact Us
 
Search for  in   Search  Advanced search  

 

Volume 16, No. 5, May 2016, Pages 1315-1326 PDF(3.89 MB)  
doi: 10.4209/aaqr.2015.04.0250   

The Effects of Morphology and Water Coating on the Optical Properties of Soot Aggregates

Meng Fan1,2, Liangfu Chen1,2, Shenshen Li1,2, Mingmin Zou1,2, Lin Su1,2, Jinhua Tao1,2

1 State Key Laboratory of Remote Sensing Science, Institute of Remote Sensing and Digital Earth, Chinese Academy of Sciences, Beijing 100101, China
2 Joint Center for Global Change Studies, Beijing 100875, China

 

Highlights
  • Optical properties calculated for two mixtures between soot aggregates and water.
  • A relationship among Df, RH and N modeled to simulate the soot aggregates shrinkage.
  • The impact of shrinking and monomer is larger for smaller particles.
  • For soot aggregate in water droplet, core shape is important when the shell is thin.

Abstract

 

Soot particles positively influence radiative forcing due to their strong absorption. Because of their chain-like structure, aggregated soot particles become more compact with the aging process, and the monomers or particles are always covered by water coatings. The optical parameters of two typical soot-water mixtures (i.e., an aggregate with core-shell monomers and a soot aggregate inside a water droplet) at 550 nm were investigated using the superposition T-matrix method, with a focus on the impact of the morphology and water coating of soot aggregates. For the soot aggregate with core-shell monomers, a relationship among the fractal dimension, relative humidity (RH) and monomer number was established and used to calculate optical parameters. The intensity of forward scattering declined with the increasing RH. The Cext, Csca, Cabs and SSA are much more insensitive to RH under higher RH conditions (RH > 90%) than at a lower RH level. In addition, hygroscopic shrinkage and the thickness of water coating have stronger effects on the optical properties of larger aggregated soot at higher RH than lower RH. For another mixing state, the soot aggregate inside a water droplet, the morphology of the soot core plays an important role in the optical properties when the thickness of the water shell is small. When the diameter ratio of the water droplet to the aggregated soot (D_ratio) changes from 1.2 to 2.8, Cext difference increases from 0.23 µm2 to 2.36 µm2 for particles with N = 100 and 500, whereas the SSA difference decreases from 0.12 to 0.01. If the agglomerated structure of the soot core is not considered, the Cext, Csca and SSA will be underestimated for a relatively small D_ratio of 1.2. Ignoring the soot core in the water droplet could introduce large errors into the calculation of the optical parameters, and ignoring the structure of the aggregated soot core could enlarge the errors.

 

 

Keywords: Soot particle; Water coating; Optical property; The superposition T-matrix.

 

 

Copyright © 2009-2014 AAQR All right reserved.