About AAQR

Aims and Scope

Articles online
For contributors
Call for Papers
Guideline for the
Special Issue Proposal
Subscription
Information

Advertising

Contact Us
 
Search for  in   Search  Advanced search  

 

Volume 14, No. 3, April 2014, Pages 783-792 PDF(1.87 MB)  
doi: 10.4209/aaqr.2013.01.0019   

Measuring and Modeling Aerosol: Relationship with Haze Events in Shanghai, China

Guangqiang Zhou1,2, Fan Yang1,2,3, Fuhai Geng1,4, Jianming Xu1,4, Xin Yang3, Xuexi Tie5

1 Shanghai Center of Urban Environmental Meteorology, Shanghai, China
2 Shanghai Typhoon Institute of China Meteorological Administration, Shanghai, China
3 Department of Environmental Science & Engineering, Fudan University, Shanghai, China
4 Shanghai Key Laboratory of Meteorology and Health (Shanghai Meteorology Service), Shanghai, China
5 National Center for Atmospheric Research, Boulder, Colorado, USA

 

Abstract

 

Observation of surface concentration of particulate matter (PM10, PM2.5) and meteorological parameters, including visibility, relative humidity (RH), precipitation, and wind speed (WS) from 2008 to 2010 were analyzed in Shanghai, China. The haze events are identified as the following: (1) Severe haze (visibility < 2 km) occurs frequently when PM10 and PM2.5 are above 181 and 115 µg/m3, respectively, with RH in between 78%–90% and WS ≤ 0.6 m/s; (2) Moderate haze (2 km ≤ visibility < 3 km) occurs frequently when PM10 and PM2.5 are greater than 114 µg/m3 and 96 µg/m3, respectively, with RH of 67%–90% and WS ≤ 1.0 m/s; (3) Mild haze (3 km ≤ visibility < 5 km) happens when PM10 and PM2.5 are greater than 96 µg/m3, 71 µg/m3, respectively, with meteorological conditions of 72% ≤ RH ≤ 90% and WS ≤ 1.0 m/s; (4) Slight haze (5 km ≤ visibility < 10 km) happens when PM10 and PM2.5 are higher than 80 µg/m3, 54 µg/m3, with meteorological conditions of 66% ≤ RH ≤ 90% and WS ≤ 1.3m/s. A typical haze event was analyzed during the MIRAGE-Shanghai field campaign (September, 2009). The results show that fine particles play very important role in haze formation. WRF-Chem, an on-line regional chemistry/transportation model was applied to simulate the haze event and its related meteorological conditions. The mass concentration of aerosol during the haze period of simulation agrees relatively well with that of observation, suggesting that the WRF-Chem model is reliable for aerosol forecasting over Shanghai. It also indicates that the implementation of combination criterion of PM2.5, RH, and WS is a potential solution for numerical forecasting of haze event.

 

 

Keywords: Haze identification; WRF-Chem; Haze forecast.

 

 

Copyright © 2009-2014 AAQR All right reserved.