About AAQR

Aims and Scope

Articles online
For contributors
Call for Papers
Guideline for the
Special Issue Proposal
Subscription
Information

Advertising

Contact Us
 
Search for  in   Search  Advanced search  

 

Volume 15, No. 4, August 2015, Pages 1325-1337 PDF(1.49 MB)  
doi: 10.4209/aaqr.2014.10.0253   

A Hybrid Approach to Forecast Air Quality during High-PM Concentration Pollution Period

Dongsheng Chen1, Tingting Xu1, Yue Li2, Ying Zhou1, Jianlei Lang1, Xiangxue Liu1, Huading Shi3

1 Key Laboratory of Beijing on Regional Air Pollution Control, Beijing University of Technology, Beijing 100124, China
2 Transport Planning and Research Institute, Ministry of Transport, Beijing, China
3 Chinese Research Academy of Environmental Sciences, Beijing, China

 

Highlights
  • Hybrid approach applies WRF and statistical analysis to forecast PM10 was developed.
  • This approach was used to forecast daily PM10 in Beijing throughout the year 2013.
  • CMAQ was also used to forecast the daily PM10 in Beijing in the same period.
  • Hybrid approach shows significant improvement during high-PM concentration period.

Abstract

 

In this study, a hybrid approach of combining numerical prediction with statistical analysis was proposed to forecast high-PM10 (aerosol particle with aerodynamic diameter less than 10 μm) concentration events in Beijing, China. This approach was used to forecast the daily PM10 in Beijing from January 1 to December 30, 2013. The WRF-CMAQ modeling system was also applied to simulate Beijing’s PM10 in the same period. The performance of the two methods was then assessed according to the mean bias (MB), normalized mean bias (NMB), normalized mean gross error (NME), mean normalized bias (MNB), mean normalized gross error (MNE), and root mean square error (RMSE). The results demonstrate that both methods perform well during low-PM10 concentration periods (PM10 concentration < 250 μg/m3), the MB, NMB, NME, MNB, MNE and RMSE for hybrid approach during low-PM10 concentration periods were 26.15, 24.88%, 41.94%, 43.23%, 56.35% and 61.67, respectively. The MB, NMB, NME, MNB, MNE and RMSE for CMAQ during low-PM10 concentration periods were –6.04, 57.47%, 41.49%, 21.52%, 55.64% and 60.11, respectively. While the MB, NMB, NME, MNB, MNE and RMSE for CMAQ during high-PM10 concentration periods (PM10 concentration ≥ 250 μg/m3) were –162.87, –50.37%, 50.37%, –49.86%, 49.86% and 175.93, respectively. The MB, NMB, NME, MNB, MNE and RMSE for hybrid approach during high-PM10 concentration periods were –30.3, –9.37%, 23.21%, –8.21%, 24.25% and 97.37, respectively. The hybrid approach shows significant improvement in accuracy during high-PM10 concentration periods.

 

 

Keywords: Particulate matter; Air pollution; Forecast system; Numerical simulation; Statistical analysis.

 

 

Copyright © 2009-2014 AAQR All right reserved.