About AAQR

Aims and Scope

Articles online
For contributors
Call for Papers
Guideline for the
Special Issue Proposal
Subscription
Information

Advertising

Contact Us
 
Search for  in   Search  Advanced search  

 

Volume 15, No. 5, October 2015, Pages 1855-1867 PDF(663 KB)  
doi: 10.4209/aaqr.2015.03.0172   

Chemical Mass Balance Source Apportionment of Size-Fractionated Particulate Matter in Nanjing, China

Pulong Chen1, Tijian Wang1, Xin Hu2, Min Xie1

1 School of Atmospheric Sciences, Nanjing University, Nanjing 210093, China
2 State Key Laboratory of Analytical Chemistry for Life Science, Center of Material Analysis, School of Chemistry and Chemical Engineering, Nanjing University, Nanjing 210093, China

 

Highlights
  • Source apportionment of size-fractionated particulate matter with CMB model.
  • Significant variations of chemical characteristics at urban and suburban in Nanjing.
  • CMB modeling shows that construction dust is the dominating source for PM10.
  • Secondary inorganic aerosols are the dominating source for PM2.1 using CMB model.

Abstract

 

In recent years, atmospheric particulate matter has become the primary air pollutant in Nanjing, China. In order to support a scientific basis for particles reduction, it is of great importance to investigate the contribution of different sources to particulate matter. In this paper, the characteristics of chemical composition of observational data for size-fractionated particulate matter at Gulou site and Pukou site in Nanjing from May 2010 to April 2011 were analyzed. Emission samples of particulate matter were collected and size-fractionated particulate chemical compositions were analyzed to obtain the source profiles. A chemical mass balance (CMB) model was applied to apportion the contribution rate of different sources. Investigations show that the annual average concentrations of PM10 (particles with an aerodynamic diameter of 10 µm or less) at Gulou and Pukou are 135.8 ± 66.4 μg m–3 and 132.2 ± 73.0 μg m–3, respectively. For PM2.1, the concentrations are 55.1 ± 36.3 μg m–3 and 64.8 ± 40.2 μg m–3, respectively. The dominant chemical constituents are SO42–, NO3, Ca, NH4+, Cl, Fe, Al, and K, accounting for 93.02% and 91.56% of all of the measured compositions in PM10 at Gulou and Pukou. These components account for 95.23% and 93.48% of PM2.1 at Gulou and Pukou. Seven types of sources, including coal combustion dust, construction dust, smelting dust, soil dust, vehicle exhaust, secondary aerosols and sea salt, are considered. The results of source apportionment show that in coarse particles, construction dust contributes a maximum of 58.9% at Gulou and 47.3% at Pukou. Smelting dust, as the second most important source, contributes 14.1% and 19.7% at these two sites. For fine particulate matter, secondary inorganic aerosols and coal dust contribution are the two largest sources accounting for 58.8% and 15.9% at Gulou and 44.2% and 39.5% at Pukou. The findings will be useful for the local government to create efficient control strategies to reduce the emission of construction dust and to pay great attention to the prevention of secondary aerosols and coal combustion dust.

 

 

Keywords: Size-fractionated particulate matter; PM2.1; CMB model; Emission source profiles; Source apportionment.

 

 

Copyright © 2009-2014 AAQR All right reserved.