About AAQR

Aims and Scope

Articles online
For contributors
Call for Papers
Guideline for the
Special Issue Proposal
Subscription
Information

Advertising

Contact Us
 
Search for  in   Search  Advanced search  

 

Volume 15, No. 3, June 2015, Pages 875-887 PDF(490 KB)  
doi: 10.4209/aaqr.2014.09.0226   

Characterization and Source Identification of Heavy Metals in Ambient PM10 and PM2.5 in an Integrated Iron and Steel Industry Zone Compared with a Background Site

Qi-Li Dai1, Xiao-Hui Bi1, Jian-Hui Wu1, Yu-Fen Zhang1, Jing Wang1, Hong Xu1, Lin Yao2, Li Jiao2, Yin-Chang Feng1

1 State Environmental Protection Key Laboratory of Urban Ambient Air Particulate Matter Pollution Prevention and Control, College of Environmental Science and Engineering, Nankai University, No.94 Weijin Road, Tianjin 300071, China
2 Hangzhou Environmental Monitoring Center Station, No.4 Hangda Road, Hangzhou, Zhejiang 310007, China

 

Highlights
  • Heavy metals on PM in an integrated iron and steel industry zone were measured.
  • Global comparison of PM heavy metals in steel-related sites was conducted.
  • Sources contributing to steel-related site were identified by PCA analysis.
  • Concentrations of industrial heavy metals were about 1–3.6 times higher.
  • Fe, Zn, Mn, Pb and Cr were regarded as the maker elements of steel production.

Abstract

 

The purpose of this study is to characterize heavy metals in ambient PM10 (particles with aerodynamic diameter below 10 µm) and PM2.5 (particles with aerodynamic diameter below 2.5 µm) particles in a typical integrated iron and steel industry zone (HG) and a background site (ZWY) during February 2011 to January 2012 in the Yangtze River Delta (YRD) region, China. Twelve elements were measured to study their levels, size distribution and sources. At the two sampling sites, Fe was found as the dominated metal in the total detected metals in both particle sizes, followed by Zn and Pb. They were regarded as the marker elements of iron and steel production emission along with Cr and Mn. The concentrations of all measured heavy metals in HG were 1–3.53 times higher than those measured in ZWY. When compared with previous studies, the concentrations of steel related elements (Fe, Zn, Mn) in this work were significantly high. The highest correlation coefficient was observed in HG for Fe and Zn. Additionally, Cd was found as the most enriched heavy metal by the enrichment factor analysis, followed by Zn, Pb, and Cu. The main sources contributing to heavy metals at HG site were identified by principle component analysis: steel dust (including coal combustion of coal-fired power plant, coke making and steel making emission), vehicle emission and road re-suspension dust and soil dust. Besides, steel dust was also found as the possible source of heavy metals at ZWY site. The result suggested the steel dust has influence on the whole study area.

 

 

Keywords: Heavy metals; Steel production; Particulate matter; Source identification.

 

 

Copyright © 2009-2014 AAQR All right reserved.