About AAQR

Aims and Scope

Articles online
For contributors
Call for Papers
Guideline for the
Special Issue Proposal


Contact Us
Search for  in   Search  Advanced search  


Volume 12, No. 5, October 2012, Pages 814-825 PDF(507 KB)  
doi: 10.4209/aaqr.2012.03.0056   

Measurement of Gaseous and Particulate Pollutants during Combustion of Date Palm Wastes for Energy Recovery

Yassine El May1,2, Sophie Dorge1, Mejdi Jeguirim1, Gwénaelle Trouvé1, Rachid Said2

1 Laboratoire Gestion des Risques et Environnement, Université de Haute Alsace, 3 bis rue Alfred Werner, 68093, MULHOUSE Cedex, France
2 Unité de Recherche d’Etude des Milieux Ionisés et Réactifs (UR EMIR), IPEIM, Avenue Ibn El Jazzar Monastir 5019, Tunisie




Being an important date-producing country, Tunisia generates high quantities of dry date palm residues which are currently not efficiently used, and instead accumulate every year in oasis lands. These by-products could present real advantages for Tunisia for energy production in both economic and environmental terms. Heating installations using biomass generate primary pollutants, such as CO, VOC and Particle Matter (PM), these latter having the most important adverse impact on environment. Measurements of these pollutants are needed, because international certification organizations require drastic limits on CO and PM emissions from biomass combustion processes.
    In this study, date palm leaflets (DPL), date palm rachis (DPR), date palm trunks (DPT) and date stones (DS) were combusted in a laboratory scale mobile furnace. The aim of this work was to find an appropriate of these materials for energy recovery, with low emission factors of gaseous and PM in the exhaust. Combustion tests were performed at two temperatures (500°C and 800°C) and input air flow rates (25 and 50 NL/h). With the lowest content of chlorine and the highest bulk and energetic densities, DS is the most convenient date palm residue for energy recovery. Combustion of DPL, DPR and DPT needs to be performed at high temperature to obtain a complete carbon balance, and this is not required for the combustion of DS, which has a value of 88% for the carbon balance at 500°C.
    Particles emitted during combustion are mainly constituted of fine and ultrafine particles. For all samples, 99% are particles with diameters below 1 μm. Combustion of DS produces the lowest content of PM0.1, leads to the lowest emissions factors of aerosols, and generates fewer tars than the other date palm by-products. An increase in the input air flow rate, and therefore decrease in the residence time during combustion of DS, generates a larger amount of aerosols.



Keywords: Thermal oxidation; Date palm waste; Gas release; Emission factor; Aerosols.



Copyright © 2009-2014 AAQR All right reserved.